Serving Duluth, Superior & nearby Minnesota and Wisconsin towns Mon–Sat 7am–6pm (715) 919-7956

Why Windows Fog Up in a Duluth Winter and How to Fix the Cause

Fog on the glass can mean too much indoor humidity or a failed window seal. Here is how to tell which, what to run, and how to repair the damaged trim.

Prefer to text? Text (715) 919-7956 · $95 visit fee, waived when you approve the work

Moisture on the room side of the glass means indoor humidity is too high for the outdoor temperature, so lower it and run your fans. Fog or haze trapped between the panes means the sealed glass unit has failed and needs replacing. Wet sills and peeling trim are repaired after the moisture is under control.

The humidity to aim for as it gets colder

Glass is the coldest indoor surface in the house, so it is where indoor moisture shows up first. The colder it gets outside, the colder the glass, and the less humidity the room air can carry before it condenses. That is why a house that is comfortable at 35 percent in November can drip on the windows in a January cold snap without anything else changing.

The U.S. EPA's moisture page reproduces a table credited to an extension specialist, with reference to the Association of Home Appliance Manufacturers, that lowers the recommended indoor level as the outdoor temperature falls (U.S. EPA). Duluth and Superior spend a good part of winter in the bottom rows.

Recommended indoor relative humidity by outdoor temperature, from the table on the EPA moisture page.
Outdoor temperatureRecommended indoor humidity
+20°F35%
+10°F30%
0°F25%
-10°F20%
-20°F15%

University of Minnesota Extension lists condensation on windows in winter as a symptom of excess moisture, says problems may occur above 50 percent humidity, and gives 25 percent as a winter target (UMN Extension). North Dakota State University Extension offers a rule of thumb for modern glass: at about 40 percent indoors, a double-pane window starts to show condensation when the outdoor temperature drops below zero, and a triple-pane window holds out until nearly -40°F (NDSU Extension). Treat the tables as a guide and your own windows as the test. A hygrometer costs little, and the glass tells you when you are over.

Fans, humidifiers and the other moisture sources

Showers, cooking, drying laundry indoors, houseplants and a humidifier all put water into the air. UMN Extension's advice is to install or repair bathroom fans, add a kitchen exhaust fan and cut back on humidifiers. The EPA adds that bath and kitchen fans should remove moisture to the outside, not into the attic.

That last point matters in an older Duluth house, where a fan duct is sometimes cut off in the attic or ends in the soffit. NDSU makes the same point: vent fans go outdoors, not to the attic, to avoid hidden moisture and mold. A fan that dumps into the attic can turn into the ceiling stain we cover in ceiling water stains after winter. Run the bath fan during the shower and for a while afterward, and run the range hood when you boil or simmer.

The EPA notes that tightly sealed, energy-efficient homes hold more moisture, so you may need to run a fan or briefly open a window. Sealing air leaks into walls and the attic, which UMN also recommends, keeps warm moist air from reaching cold framing. Our winterizing checklist covers the seals and weatherstripping that go with it.

Humidity problem versus failed seal

Where the moisture sits tells you which problem you have. Use the table before you spend anything on glass.

What the location of the moisture usually means.
What you seeUsually meansWhat to do
Fog or beads on the room side of the glass that wipe awayIndoor humidity too high for the outdoor temperatureCut moisture sources, run fans, lower the humidifier setting
Frost on the room side that melts and runs onto the sillThe same cause, with cold glass or a drafty sashLower humidity first; add an interior storm or seal the frame
Haze, droplets or mineral film between the panes that never wipes offThe sealed glass unit has failedReplace the glass unit or window; check the warranty first
One window fogs while its neighbors stay clearA local cause: a blocked vent, heavy drapes, or a failing sealOpen the drapes at night; check that window's seal
Dark, soft or peeling wood at the sill and bottom of the jambRepeated wetting over several seasonsFix the moisture, then repair the wood

NDSU says condensation on double- and triple-pane windows usually means indoor humidity is too high, which fits the first rows. The EPA adds that storm windows and sealed frames keep the inside glass warmer and cut condensation. Between-the-pane fog is different because the moisture is inside the sealed space, where you cannot wipe it. Once that seal is gone, the window loses insulating value, and the usual repair is a new insulated glass unit or a new window.

A new window is a decision about the whole opening. Insert versus full-frame replacement in older homes walks through it, and our planning range for an insert replacement is $400–$900. Windows still under warranty may be covered, so check before anyone touches the glass. NDSU also notes that dehumidifiers are generally ineffective once indoor humidity is already below 50 percent, which is common in winter, so a dehumidifier is not the fix for a January window.

Repairing the sill, jamb and trim afterward

Dry the cause out first, or the repair will fail again. Then probe the wood with a screwdriver: sound wood resists, and rotted wood gives. Peeling paint and dark staining on sound wood can be scraped, sanded, primed and repainted. Soft wood is cut back to solid material and replaced with new stock, or built up with a wood repair compound where the damage is shallow, and the joint to the glass is caulked again.

Drywall or plaster around the opening that stayed wet may be stained or soft. A small damaged patch can be cut out and rebuilt, and larger areas raise the questions we describe in plaster versus drywall repair. If wet material stays dark, soft or musty after drying, it is replaced and not painted over.

One warning for older homes: paint on pre-1978 window sills may contain lead. Scraping and sanding it falls under the rules in lead-safe renovation in older homes. We handle the stain, rot and caulk side of door and window repair. Replacing a failed glass unit is a glazing job, and rerouting a fan duct through the roof goes to a roofer or HVAC contractor.

What should indoor humidity be in winter when it is below zero?

About 25 percent at zero degrees and 15 to 20 percent when it falls to -10 or -20, according to the table on the EPA's moisture page. Those numbers feel dry, so use a hygrometer and watch the glass. If the windows stay clear, you are within the limit for that window and that temperature.

How do I know if my window seal has failed?

Look for haze, water droplets or a cloudy film between the two panes that you cannot wipe off from either side. Fog that wipes off the room-side glass is humidity, not a seal. A failed seal does not heal, and a sealed unit needs replacing; check the manufacturer's warranty before you pay for it.

Do bathroom fans really need to vent outside?

Yes. The EPA says bath and kitchen fans should remove moisture to the outside, not into the attic, and NDSU Extension says the same about venting outdoors. A fan that ends in the attic pushes damp air onto cold framing and insulation, where it frosts in deep cold and then drips in spring.

Can you repair a rotted window sill instead of replacing the window?

Often, yes, when the glass and sash are sound and the rot is limited to the sill, stool or bottom of the jamb. The soft wood is cut out and replaced or rebuilt, then primed, caulked and painted to match. If the frame is rotted through or the glass unit has failed, replacing the window is the better answer.

Have a fogging window, a stained sill or damp trim? Send photos and your address, or call or text (715) 919-7956, and you get a written quote before any work starts.

Next steps. The details of the job are on our door and window repair page, with prices in How Much Does Window Replacement Cost in Duluth, MN? or How Much Does Door Lock or Deadbolt Replacement Cost in Duluth, MN? Based in Duluth, serving Superior.

Keep reading: Hermantown & Proctor Home Repair: Permits and Local Tips and Can a Ceiling Fan Replace a Light Fixture? Duluth, MN Guide.

Get a flat written quote for this project

Tell us what you see, with a few photos if you can. The quote comes back flat and in writing.

Prefer to text? Text (715) 919-7956

  • $95 visit fee, waived when you approve the work
  • Same price across the service area
  • Insured, background-checked staff