Handyman in Hermantown, MN

You pay a flat $95 visit fee, the same as in Duluth, and it is waived when you approve the work. After the visit you get a quote in writing for the whole job, approved before any work starts, so the price doesn't climb by the hour. For planning numbers on common jobs like drywall patches, fixture swaps, deck repair and pressure washing, see our Twin Ports handyman cost guide. To start, call or text photos to (715) 919-7956.

Yes. Hermantown requires a building permit to replace roofing, siding, windows or doors, according to the City of Hermantown Building Inspection FAQ. Kitchen appliances, interior painting and flooring need no permit. Electrical permits and inspections go through the Minnesota Department of Labor and Industry, and any new circuit on your job is done by a licensed electrician under an electrical permit.

Yes. Vinyl and painted siding gets a low-pressure soft wash with a cleaner that kills the green algae on shaded walls, and higher pressure goes only on surfaces that can take it, like concrete driveways, walks and some decks. Our planning range for washing a house is $220–$450, with decks and concrete quoted as add-ons. A deck headed for new stain is washed first and left to dry. See exterior repairs and pressure washing.

Usually, yes. We replace soft or split boards, re-anchor loose railings and swap worn stair treads, and rotted posts or joists can often be replaced without a rebuild. Once new boards have dried, a fresh coat of stain helps them blend. Our planning range for board and railing repair is $800–$3,500, and your written quote is the real number. If the frame is too far gone, we show you why and quote a new deck. See deck repair and deck staining.

Yes. Common updates in houses from the 1990s and 2000s are swapping hollow-core interior doors and brass hardware, replacing dated light fixtures, ceiling fans and faucets, and putting luxury vinyl plank over worn carpet. Our planning ranges are $180–$350 per prehung door, $95–$220 per light fixture and $3–$7 per square foot for LVP labor. A like-for-like fixture swap reuses the existing wiring, and any new circuit is run by a licensed electrician under an electrical permit. See carpentry, lighting and flooring.

Yes. A tub-to-shower conversion means pulling the tub, checking the subfloor and framing, moving the drain and valve to suit a shower base, and waterproofing the walls before tile or panels go up. Plumbing changes are done under the required permit. See shower and tub-to-shower remodeling in Hermantown, then send photos of the tub, the valve wall and the floor for a flat quote.

For a fence, yes: Hermantown requires a fence permit for every fence, and a building permit too once it's 7 feet or taller. A shed or other building of 200 square feet or smaller doesn't need a building permit (City of Hermantown), though setbacks still apply. Hermantown's building department is run under contract by SAFEbuilt; the permit offices by town page has the numbers.

Decks, exterior caulk and weatherstripping are usually the first things to need work. Original pressure-treated decks develop soft boards, loose railings and worn stairs; caulk around windows, doors and trim shrinks and cracks; and door sweeps flatten out. Inside, expect nail pops, winter ceiling cracks from truss uplift, sagging or sticking doors, and dated faucets and fixtures. Text photos of the whole list and we'll put it on one written quote.